GOMING 5V 5M WS2812B COB LED Strip Light Individually Addressable 800 Pixels Dream Color IP20 Not Waterproof White PCB LED Strips for DIY

Features

• 【COB LED STRIP】160LEDs/M, 800LEDs/5M, COB light strips have more dense LED chips, Which make the emitting units nprecedentedly close to each other, and create super even lighting performance. At the same time, it brings higher luminous efficiency.
• 【WS2812B LED Strip】 5M 800 Pixels LED Strip, Each LED can have its own color and brightness, which can show dreamy colors.The default pixel point of many WS2812B controllers is only 120. When using the controller, you need to set the pixel point to 800 and above, otherwise the light strip may have lamp beads that are not bright.
• 【Dream Color】 WS2812B led strip can show Flowing water, chasing light, trailing, jumping, raindrops, and so on hundreds of lighting effect (Controller and power supply are necessary, but do not include controller and 5V power supply).
• 【Easy to Install】 The strip come with adhesive on the back, it can be pasted on the table, cabinet, glass, car, or wall. Each 1.2cm can be cut without affecting the work of other lamp beads.
• 【Easy to Connect 】The light strip is pre-welded with JST-SM connectors, which can be easily connected. And pre-welded voltage-increasing wires, you can increase the voltage according to specific requirements.

Product Description

Description: IC type: WS2812B IC Gray level: 256 View angle: 180° Input voltage: DC 5V Color: full color 24-bit FPCB board color: White Power:13W/M Recommended power supply：DC5V 10A (50W) Standard Reel Length: 5M/roll Operating Temperature: -20 ~ +40°C Led Qty: 160LED/M Length xWidthx Height: 5000mmx10mmx3mm Wave length(nm): Red,650nm ; Green,520nm ; Blue,460nm Waterproof level: IP20 No-waterproof Precautions: Using voltage DC5V, higher than 5V will destroy it. It is better to add DC5V voltage every 5M, because the LEDs at the far end of the strip might be dimmer due to the added resistance and voltage drop that occurs as the current flows to that end of the strip Package: 1x 5M WS2812B IP20 800 LEDs strip White PCB Power adapter or controller is not included （Please use DC5V power supply） Common problem: 1.Why the end of LED strip looks like red or yellow when you light up maximum brightness White Light A1: It is better to add DC5V voltage every 5M, because the LEDs at the far end of the strip might be dimmer due to the added resistance and voltage drop that occurs as the current flows to that end of the strip. 2.Why do I light up a few LEDs A1: Please make sure you using the right power supply . For this LED strip , it is DC5V .Please don't use DC12V power supply for it. It will burn this LED strip. A2: The controller is defective . Please make sure the controller can work fine . 3.What are the functions of the two extra wires on two ends ,one is white ,one is red A1: They are using to connected the DC5V power supply when the LED strip out of voltage . So we also call them voltage adding wires . 4.Can I connect them in series when I want to control 4 reels of them A1: Yes , they can end to end connct many reels .