Hobbywing XRotor Micro Combo Stack (F7 FC + 40A BLHeli_32 ESC)

The XRotor Micro Combo from Hobbywing continues to impress with its latest iteration. The Micro Combo features a 40A 4-in-1 ESC along with an updated F7 Flight Controller. This new FC is similar to other versions with its OSD, and voltage monitoring, but the F7 now comes with an all-new 5V & 12V dual BEC Circuit and a special interface for the DJI image transmission system.

Make your electronics stack work for you, not the other way around!

Manual

• XRotor Micro F7 Flight Controller Manual
• XRotor Micro 40A 20x20 ESC Manual

Features

F7 FC

• Equipped with STM32F722 MCU which has powerful computing ability and fast running speed, and high sensitivity ICM20602 six-axis motion sensor.
• Supports BetaFlight, Cleanflight, Butterflight, Inva, and other mainstream FPV firmware.
• DJI image transmission system port equipped with corresponding flat cable
• Supports bidirectional DShot digital throttle communication.
• Unique installation design and shock absorption structure.
• On-board large capacity Flash memory chip.
• On-board 5V & 12V dual BEC circuit.
• On-board Pit Switch module.#

40A 4-in-1 BLHeli_32 ESC

• All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
• The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us), and Multishot (5-25us).
• Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power-up.
• High-performance 32-bit microprocessor with a running frequency of up to 48MHz for an excellent performance.
• BLHeli_32 firmware is the third generation BLHeli.
• Unique Soft Mounts

Specifications

F7 FC

• Compatible with (Modes): PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, DShot1200, Proshot1000 and etc
• Compatible with (Transmitters): PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL
• Mounting Holes: Convertible 20x20mm / 30.5x30.5mm
• Programming via: Betaflight/Cleanflight-configurator
• Firmware: HOBBYWING_XROTORF7CONV
• Voltage Monitoring: Supported
• Current Monitoring: Supported
• FC Programming: Supported
• External Buzzer: Supported
• BEC: 5V@1.5: 10V@1.5A
• LED Control: Supported
• USB Port: MicroUSB
• Size: 32x32mm
• OSD: Built-in
• Weight: 3.3g

40A 4-in-1 ESC

• Connectors: (In) XT60 (w/ Wires Soldered on) / (Out) No
• Input wires: 14AWG-100mm* (Red/Black)
• Output Wire: No wires but solder tabs
• Weight / Size: 12.0g / 40x33x5mm
• ESC Programming: BLHeliSuite32
• Throttle Calibration: Supported
• Mounting holes: 30.5x30.5mm
• LiPo Power input: 3S-6S
• Burst Current: 60Ax4
• Cont.Current: 40Ax4
• BEC Output: No

Included

• 1x Hobbywing XRotor Micro Combo Stack - F7 FC + 40A 4-in-1 BLHeli_32 ESC
• 1x Soft Mounting Grommets Set
• 1x Signal Cable