Happymodel SuperBee F4 Lite AIO Whoop Flight Controller

Happymodel SuperBee F4 Lite AIO Whoop Flight Controller

€46,95

FAST DIspatch & Global delivery
Quality Assured Brand Manufacturer

Receiver:

ELRS 2.4Ghz

SPI Frsky

SKU: 2D30058 Category: Racing & Flight Sim Hardware - Steering Wheels / Pedals / Shifters / Accessories. Tag: Shopify Collective, Unmanned Tech

Description
Product Reviews

Since the solder joints of the flight controller are small and compact, please be careful when soldering. Any problems caused by soldering will void warranty, no replacement can be provided free of charge. But it can still be sent back for repair.

Setup Notes

This flight controller setup at the factory for the Mobula6 HDZERO, the original default device for OSD is "MSP" If you plan to use this FC for for analog FPV camera, you need to activate the OSD :
First connect to betaflight configurator , and type the CLI command, and enter "set osd_displayport_device = MAX7456", then reconnect betaflight ,upload osd font. The update font option is important that many users forget about!

Also depending on supply you may receive a different Gyro, refer to the diagram below to see what orientation to use.

Specification

Flight controller SuperbeeF4 Lite ELRS/FRSKY	SPI ELRS version Firmware target: CrazybeeF4SX1280 SPI FRSKY version Firmware target: CrazybeeF4FR MCU:STM32F411CEU6 (100MHz, 512K FLASH) Sensor: MPU-6000 or ICM20689 or BMI270(SPI connection) Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD(SPI Control) Built-in SPI Frsky/ExpressLRS receiver Built-in 5V 1A BEC Built-in voltage detection
Onboard 4in1 ESC	MCU upgraded to EFM8BB21 Power supply: 1S LiPo/LiPo HV (2.8v~4.35v) Currents: 5A continuous peak 6A (5 seconds) Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_8.HEX Default protocol: DSHOT150/DSHOT300/DSHOT600
Onboard SPI ExpressLRS 2.4GHz Receiver	Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz RF Frequency: 2.4GHzAntenna plug: IPEX Telemetry output Power: <12dBm Receiver protocol: SPI ExpressLRS Could bind with ELRS V2.0 firmware TX module
Onboard Frsky SPI D8 /D16 2.4GHz Receiver	SPI BUS receiver Frsky D8/D16 compatible Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)Channels: 8ch or 16ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol