The VTX[T] is not just another FPV video transmitter, it has been built to pack all the latest technology into a small and affordable package. This is aimed to be a viable alternative to the more expensive TBS unify, or immersionRC tramp video transmitters. This VTX supports a wide range of power input (7-26V), will output a constant 5V to your FPV camera, and is able to switch between 25, 200, 600, and 1200mW of transmission power.

Key Features

• Smart Audio support but can still use button and LED indicators to change/view current power, band and channel.
• Built in microphone
• 30x30 stack compatible (30.5x30.5mm hole spacing)
• Better protection thanks to the integrated heatsink and casing to help protect the internal components
• Solder connections and plug depending on your connection preference
• 7-28V input with 5V output to power your camera

Specifications

• Input Voltage: 7V to 28V
• Extra Features: Smart Audio 1600mW
• Power Supply: 5V Camera (max 500mA)
• VTX Transmission Power: 200mW, 400mW, 800mW, 1600mW)
• Range: Bonkers - use with good antennas for the ultimate analogue video setup
• Antenna Connector: SMA Female (pigtail) / MMCX (direct to VTX)
• Port Connector: Solder pads, jst-sh 6pin
• Weight: 17g
• Dimention: 36x36mm

Kit Contents

• 1x Chaos Pro VTX
• 1x Cable pack
• 1x MMCX to SMA adapter cable
• This VTX does not include any antenna

VTX Table - Copy and paste into betaflight CLI

vtxtable bands 5
vtxtable channels 8
vtxtable band 1 BOSCAM_A A FACTORY 5865 5845 5825 5805 5785 5765 5745 5725
vtxtable band 2 BOSCAM_B B FACTORY 5733 5752 5771 5790 5809 5828 5847 5866
vtxtable band 3 BOSCAM_E E FACTORY 5705 5685 5665 5645 5885 5905 5925 5945
vtxtable band 4 FATSHARK F FACTORY 5740 5760 5780 5800 5820 5840 5860 5880
vtxtable band 5 RACEBAND R FACTORY 5658 5695 5732 5769 5806 5843 5880 5917
vtxtable powerlevels 4
vtxtable powervalues 0 1 2 3
vtxtable powerlabels 200 400 800 1600
save

Exit Pit Mode via hardware button

If for whatever reason you cannot get the VTX out of pit Mode (you don't get much more than 1m range), then please press and hold the hardware button for 20 seconds until you will see the three red LED will stop blinking, this means the device is no longer in PIT mode.

Pinout

Warning

It is your responsibility to ensure that the use of this product meets the requirements imposed by your government's rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. Unmanned Tech cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations. By agreeing to our terms and conditions during the check-out process, you also agree to have read and to understand this notice.